On the left side under 'Clients' you will find 10 LEDs which indicate the associated clients, on the right side under 'TRIGGER POINTS' all those signals which are above the trigger threshold with indication of frequency and signal level.

Another evaluation option is available after activating 'HIST.' .. You will now see the frequency of signals on the associated frequency in the second column instead of the signal level.
All values like frequencies, modes, signal levels, but also complete distributions can be distributed over the network for further evaluation. If 'SOLID' is deactivated, the histogram can be seen better. You could also command VRFlash to output data of trigger points by sending 'SYSTEM:SLOTS?'

system:slots?

 

How to enter the trigger level:

Right-click on the spectrum. For fine adjustment, scroll with the mouse wheel while holding the 'Ctrl' key.

How to position the markers:

Click the 'MARKERS' button and position the mouse pointer for the Marker1 at the desired location. Hold down the 'SHIFT' key and press the left mouse button. Do the same for MARKER2, but click with the right mouse button. Both markers can be finely moved with the mouse wheel while pressing the 'SHIFT' key. The numerical values ​​can be found below the waterfall.

How to record a spectrum:

Method 1: Press 'TS' (= Take Sweep)
Method 2: Press TRACES
                       Press LOOP
                       Press RECORD
Recording starts and the elapsed time is displayed on the RÉCORD button.
Click the TRACES, LOOP or RECORD button stops recording.

How to play a spectrum:

Click TRACES and LOOP, then PLAY. . In the dialog that appears, select a file.

How to work with the database addon:

Start VR Flash
Start the database addon
As 'Device' select 'AOR [NEW]' at the bottom of the list
Click 'Connect'
As 'Port' enter '54080' (without hyphen)
'localhost' is just fine
As 'Description' enter 'AR 5700D'
Click 'OK
Click 'OK'
Select 'File -> Open -> Database ->AOR.MDB
Select 'Channeltable -> Open'
Select 'Devices -> On/Off' or press F7
Now the frequency and level should be visible in the database too
IN VRFlash press '-> DB' and now the complete status of the receiver will be stored to the database which is MSAccess. I already imported the current EiBi list for you but you can do it yourself, ‘Database –> Import EiBi’.
You may edit the contents by simply in-place editing of the corresponding field and also restructure the appearance of the table to suit your needs but you must obey some rules e.g. do not enter ‘6k’ but 6 k’
A double-click will tune the rx with all parameters to the desired frequency. If field ‘STATION’ is not empty it will be displayed in VRFlash.

How to work with scripts:

Download  the 'Triggerdata_2.VRS' file to your computer. Then proceed as above and connect to VRFlash by pressing F7. This time select 'Extras -> VisualRadio Basic'. In the file open dialog navigate to and and double-click on the file name 'Triggerdata_2.VRS. Now the script is loaded. Press F5 to run. End the script via 'Run -> Break' or the stop button.